Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
precautions, restrictions and WarninGs
additional procedures for reuse
The equipment can be reused in undetermined, i.e. unlimited, quantities, only needing
to be cleaned and disinfected.
corrective and preventive maintenance and
preservation
cleaning and disinfection
Important: Before cleaning or repairing this equipment be sure it is disconnected from
mains power.
The cleaning procedure below should be executed at the start of the
working day and after each patient.
Always turn off the main switch before executing the procedures of daily
maintenance.
To clean the equipment, we recommend the use of "BactSpray (Reg nº
MS: 3.2079.0041.001-5) or any other similar product:
Active component: Benzalkonium chloride (tri-quaternary ammonium)
Solution 50%................................................. 0.329%
Chemical composition: Butyl Glycol, Decyl polyglucose, Sodium
Benzoate, Sodium Nitrate, Essence, Deodorized Propane / Butane,
demineralized Water.
For more information concerning cleaning procedures, see manufacturer's
instructions.
WARNING:
- In order to prevent risks and damages to equipment, make sure that
the liquid does not enter into the unit.
- The application of other solvent-based cleaning products or sodium
hypochloride isn't recommended, because they may damage the
equipment.
Note: Use gloves and other
systems of protection,
during the disinfection.
disinfection and sterilization
- Use clean and soft cloth dampened in alcohol 70% to disinfection of the equipment.
- Never use corrosive disinfectants or solvents.
The light conductor should only be sterilized in the following conditions:
- Maximum temperature of 134ºC.
- The light conductor should be duly clean when it is packaged.
- Do not sterilize the light conductor in contact with other types of material.
44
Attention: Do not use any
disinfectant spray, as the vapor
may be inflammable, or it may
cause injury.
Publicidad
Capítulos
Tabla de contenido
