Grounding Instructions; Extension Cords - Clarke American Sanders CAV12 Manual Del Operador

INTRODUCTION AND INSTRUCTIONS, cont.
WARNING: Wood and varnish sanding dust could self ignite and cause
injury or damage. If these substances have been picked up with this ma-
chine, empty immediately after use, into a metal container.
Operation Switch
The operation switch is located on the control panel (see fi gure 2). To activate, turn
the switch clockwise. See that the switch is turned off before connecting or discon-
necting the plug.
Removing or Securing the Head
The head is held to the tank by two clamps. Lift the clamps to release it from the tank
(see fi gure 3). Press in on the clamps to secure it to the tank.

GROUNDING INSTRUCTIONS

This appliance must be grounded. If it should malfunction or breakdown, grounding
provides a path of least resistance for electric current to reduce the risk of electric
shock. This appliance is equipped with a cord having an equipment-grounding conduc-
tor and grounding plug. The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
WARNING: Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualifi ed electrician
or service person if you are in doubt as to whether the outlet is properly
grounded. Do not modify the plug provided with the product - if it will not
fi t the outlet, have a proper outlet installed by a qualifi ed electrician.
This appliance is for use on a nominal 120-volt circuit and has a ground plug that looks
like the plug illustrated in fi gure 4. Make sure that the appliance is connected to an
outlet having the same confi guration as the plug. No adapter should be used with this
appliance.
WARNING: To prevent possible electric shock, protect the machine from rain.
Keep the machine in a dry building.
WARNING: To prevent possible electric shock, always use a 3-wire electrical
system connected to the electrical ground. For maximum protection against
electrical shock, use a circuit that is protected by a ground fault circuit inter-
rupter. Consult your electrical contractor.
WARNING: Do not cut, remove or break the ground pin. If the outlet does not
fi t the plug, consult your electrical contractor.
WARNING: Have worn, cut or damaged cords replaced by an authorized
service person.

EXTENSION CORDS

Use only an approved extension cord with three conductors, a plug with three termi-
nals, and a connector body with three holes. The machine has a power cord with wire
size 16 AWG (AWG means American Wire Gauge).
WARNING: If you use an extension cord, use an extension cord with mini-
mum wire size 14 AWG. Do not use an extension cord longer than 50 feet.
Do not join two extension cords.
American Sanders Operator's Manual (EN) - CAV 12
®
Clarke
ENGLISH
EN
Figure 2
Figure 3
Grounded
Grounded
Outlet
(A)
Box
Figure 4
FORM NO. 71073A - 5 -
Outlet