OMG AccuTrac Manual Del Propietário página 10

Problem: Tool Will Not Retract into Full Upward Position
POTENTIAL CAUSE
Operator is not allowing tool to fully retract
Ejector blade or tubes are dirty
Nosepiece is bent or damaged
Fastener wedged between feed tube
and nosepiece
Problem: Tool is Sluggish
POTENTIAL CAUSE
Ejector blade needs lubricating
Dirty upper and lower tubes, ejector blade
guides and drive bar slots
Upper and/or lower tubes are bent
or damaged
Nosepiece retaining screw is worn or
the nosepiece is damaged
If you have followed the recommendations above, but your problems persist, please call the OMG Roofing Products Technical
Services Department at 1 . 800 . 633 . 3800.
REMEDY
Downward pressure on tool must be fully released after the plate has
been fastened. Tool should "spring" up into correct position. If necessary,
tug upwards.
Clean and oil ejector blade and tubes.
Call 1 . 800 . 633 . 3800 for service. Do not attempt to remove nosepiece.
Remove feed tube and clear fastener jam.
REMEDY
Lubricate the ejector blade.
Remove debris. Clean all parts with a degreaser and lubricate.
Replace worn or damaged tubes as needed.
Call 1 . 800 . 633 . 3800 for service. Do not attempt to remove nosepiece.
OMG ROOFING PRODUCTS
800 . 633 . 3800
WWW.OLYFAST.COM
9