Equipment Description; Main Components Of The Machine - Sagola AQUAPLASTIC+ Manual De Instrucciones

The AQUAPLASTIC PLUS is manufactured entirely
of AISI 304 steel; consisting of three tanks.
1) Upper tank used for manual washing of parts,
containing a working grid on which the clean
objects can be placed.
A pneumatic mixer is located inside the tank that
is needed to mix the flocculant and the dirty paint
water.
2) Intermediate tank, called the filtering tank,
where the filter is positioned that stops the paint,
letting the clean water pass into the lower collec-
ting tank.
16
4
8
15
12
11
6
5
10

5. EQUIPMENT DESCRIPTION

6. MAIN COMPONENTS OF THE MACHINE

7
18
21
1
1. Safety pictograms
2. Blow Gun
3. Quick connector plug
4. Grid
5. Fabric filter
9
6. Exhaust
7. Mixing tube
8. Wash basin cleaning
9. Deposit bottom
10. Chapa-back filter
3) Lower tank, called the collection tank, from
which a pneumatic pump aspirates the filtered
water, allowing it to return to the washing cycle.
This tank is fed upwardly by a filter plate that
respectively supports a fabric filter in non-woven
fabric to allow the filtering of water coming from
the washing tank.
The washing of parts that are dirtied with paint
takes place manually with the atomizer brush.
Inside this cabin there is an atomizer brush with a
relative drip course, which allows the cleaning of
parts with filtered water as well as the water
coming from the water network.
3
- 15 -
13
14
2
17
20
19
11. Absorption Probe
12. Cover plastic basin
13. Nameplate
14. Nameplate ATEX
15. Brush
16. Dripping Brush
17. Brush ON/OFF valve
18. Mixing controller
19. Ground connection
20. Ground wire
21. Water gun