Rating Plate; Operation And Handling; Before Initial Use; Preparation Of The Waterfilter - CASO DESIGN HW 600 Manual Del Usuario

Volume-button: Set the water volume according to 100ml, 150ml, 200ml, 250ml,
300ml, 350ml, 400ml, 000 (continuous water flow)
Start/Stop-button: Start and stop the dispense of water.
Clean-button: For setting of water hardness and start of cleaning and descale
function.

13.3 Rating plate

The rating plate with the connection and performance data can be found beneath the device.

14 Operation and Handling

This chapter provides you with important notices with regard to operating the device. Observe
the following notices to avoid dangers and damages.
► Do not leave the device unsupervised during operation.

14.1 Before initial use

14.1.1

Preparation of the waterfilter

1. Remove the waterfilter from all packaging. There may be a small residue of black carbon
particles in the bag or on the filter body. This is normal. These particles are harmless and
will be washed off during the preparation process.
2. Soak the waterfilter upright in water for 10 min.
3. Rinse the waterfilter thoroughly under running water.
4. The waterfilter is now ready for use.
► The lifetime of the waterfilter lasts about 4-6 weeks of normal use (filtering of
approximately 150 l water in total).
► Store the replacement filters in a cool location, out of direct sunlight and away from heat
sources.
14.1.2

Preparation of the device

1. Place device without drip tray.
2. Fill the tank up to max marking.
3. Place vessel below the spout which can collect whole content of watertank.
4. Start the device with 000 temperature setting until ca. 300 ml water is dispensed.
Warning
Please note
33