Cleaning And Maintenance; Safety Information; Cleaning And Descaling; Cleaning And Descaling Function - CASO DESIGN HW 600 Manual Del Usuario

15 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining the
device. Please observe the notices to prevent damages due to cleaning the device incorrectly
and to ensure trouble-free operation.

15.1 Safety information

Please observe the safety instructions, before cleaning your device
► Unplug the device when not in use and before any cleaning.
► Never immerse the unit, cord or plug in water or other liquids and do not place in the
dishwasher.
► Do not use iron brush, abradant, kitchen cleaner, or sharp cleaning tool for cleaning.

15.2 Cleaning and descaling

Wipe the device with damp cloth.
Drainage stopper
After cleaning of the device, please take out the
drainage stopper (3) in order to clean up waste
water. Put the drainage stopper back in after
opening it. Make sure it is fastened properly.
► If you need to send the device to customer service, then first remove the water from the
device.
15.2.1

Cleaning and descaling function

When "Descale" is blinking in the display then the device needs to be descaled, please
proceed as follows:
Place device without drip tray and without water filter. Fill the watertank up to max marking.
Add a little bit of vinegar.
Place vessel below the spout which can collect whole content of watertank.
Press Clean-button. The display shows „50" as temperature. With
can select between 50, 80 und 100°C. We recommend 80°C. Start the process with
Start/Stop. The device dispenses whole content of watertank and will be cleaned and
descaled. Pour the water away. Rinse the watertank with fresh water after this.

15.3 Storage

If the device is not used frequently, unplug and clean it, then put back into the original
packing box to avoid that the electrical components from getting humidified or damaged.
Attention
Please note
Temp-button you
36