Parallel Guide - Rubi TC 180 Manual Del Usuario

Water Valve
WARNING: Great care must always be taken
to avoid the risk of electrocution whenever
using water. Never allow water to contact
the electrical parts of the tool. Always use a
PRCD Interrupter.

PARALLEL GUIDE

The Parallel Guide allows straight cuts to a desired
distance from the edge.
To mount, insert the Parallel Guide into the slot in
the Base Plate and tighten the Thumb Knobs at the
desired position. See fig. 7.
Parallel guide
STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the same
as that shown on th especification plate of the
machine and that switch is "OFF" before connecting
the tool to the power circuit.
Keep the machine steady during switching and during
use by holding the main handle and the secondary
handle with both hands.
TO SWITCH ON:
This machine is equipped with a "LOCK-OFF"
switch. To press the switch, you must first press the
release button located at the top of the switch. Then
the trigger switch will be free to be pressed to start
the machine.
18
ENGLISH
ORIGINAL INSTRUCTIONS
TO SWITCH OFF:
Release the trigger switch to stop the machine . Af-
ter the machine has been switched off, the blade will
still rotate for a time, take care that parts of your
body do not come into contact with the blade while
it is still rotating!
Fig.6
ELECTRONIC OVERLOAD PROTECTION
If while cutting the machine reaches a load approa-
ching overload level, the electronic overload protec-
tion will kick in and shut the saw off. When this hap-
pens, release the trigger and return the machine to
its topmost position (out of the cut) and wait at least
3 seconds before continuing.
HOW TO USE THE TOOL
Effective control of this powerful saw requires two-
handed operation for maximum protection. Note
there is a secondary handle as well as a side handle
which has two choices of position. Choose the han-
dle according to the working conditions. Support
the work properly and to hold the saw firmly WITH
BOTH HANDS to prevent loss of control which
Fig.7
could cause personal injury. Always hold one of the
auxiliary handles with the left hand and the main
handle with the right hand for proper hand support
of the saw. Protect your eyes from injury with safety
glasses or goggles.
OPERATION
1. Adjust the depth of cut.
2. Draw a cutting line before beginning cutting so it is
easy to make straight cuts.
3. Place the machine in position on the workpiece.
4. While the blades are not yet in contact with the
workpiece, press the lock button squeez e the tr igg
er and allo w the machine to reach full speed.
5. Holding firmly with both hands, slowly advance the
machine until it makes contact with the workpiece.
On/Off trigger switch
Release Button
Fig.8