Kobe Range Hoods Brillia RAX9430SQB Instrucciones De Instalación Y Manual De Operación página 9

3. Place rubber seal on hood venting area; make sure
the openings on rubber seal are aligned with
openings in vent area.
rubber seal and attach to hood using six (M4 x
16mm) screws (provided). Refer to Figure 5.
4. Secure two mounting screws (not provided) to the
wall, leaving an 1/8" space from the wall.
5. Align the hood-mounting bracket to the mounting
screws on the wall and hang hood into place. Refer
to Figure 6.
6. Secure and
CAUTION: MAKE SURE THE HOOD IS SECURE
BEFORE RELEASING.
Ductwork Installation
7. Using Reference
measurements on Page 13, mark the leveling point
for duct cover-mounting bracket.
8. Secure the duct cover-mounting bracket to the wall
with two screws (not provided). Refer to Figure 7.
Make sure all screws are tightened. NOTE: Inner
duct cover will cover the duct cover-mounting
bracket.
9. Use 6" steel pipe (follow building codes in your
area) to connect the plastic exhaust on the hood to
the ductwork above. Use duct tape to ensure all
joints are secure and air tight as shown in Figure 8.
Align plastic exhaust on
tighten the mounting
E from Table
Figure 5
screws.
Figure 6
1 and
Figure 7
Figure 8
7