Operating Instructions; Handling - Hydas hydrofit WE-999-5HRI Instrucciones Servicio

6 | Operating instructions

Make sure the room temperature is right. The temperature in the bathroom
should not fall below 25°C.
a
Place the unit's mains plug into wall outlet. The item is now ready for use.
Tip: Tip: let the fan warm up for 5-10 minutes; this avoids a cooling effect on
the skin due to the jet bubbles. The warm-air whirlpool mattress produces
warm air that prevents bath-water from cooling too quickly.
b
Put the air spray mat in the tub and press down on it firmly. So that the
suckers on the base of the air spray mat stick better, rinse down the mat a
little before laying it in the tub. Make sure that the mat is lying firmly on
the base and does not slip.
Note: To take the mat out of the bath after use without any damage, press the
sucker away with fingernails. Then GENTLY pull the side of the mat away from
the bottom of the bath.
c
Place the color adapter on one end into the softmat and on the other end
into the hose. Please be sure all connections are firmly in place.
d
Add 1-2 drops of aromatic oil to the cotton fleece and close the aroma clip.
(Fig.2)
e
Push the aroma clip into the set adaptor. (Fig.3)
f
Connect the hose to the set with the set adaptor and rotate to secure it.
(Fig.4)
Note: Commercial aromatic oils can be used. Following use, remove the cotton
wool fleece from the clip. An excess of aromatic oil can damage the aroma clip.
g
Let in the bath water at the right temperature.

7 | Handling

Turn on appliance and select intensity or programme mode. Slowly step into
the bath. The sprinkler bath can be controlled directly from the set by means
of a 4-setting switch or with the remote control.
18
Fig. 2 Fig. 3 Fig. 4