How To Operate - Igloo IBC41SS Manual De Instrucciones

HOW TO OPERATE

Before first use, remove all adhesive tape from the drawers, shelves, trays and drain tube
plug.
INSTALLATION
1. The BEVERAGE COOLER should be placed on a completely flat surface. Allow 1 foot of space
on each side of the cooler and between the cooler and the wall. Also allow at least 8 inches
of space between the top of the cooler and the ceiling.
2. Choose a location for your cooler that is not exposed to sunlight, high temperature or
humidity, as humidity may stain and damage the cooler.
3. The appliance can be adjusted by rolling the two adjustable legs in the bottom front of the
refrigerator if it becomes unstable. Raise the cooler by rolling the two legs clockwise.
4. The surface of the location where the cooler is installed should be firm and flat. If cooler is
not secured in a proper location, noise and vibration may occur. The noise may be increased
if the floor is not firm. If you have to position the cooler on a carpeted floor, place a sheet
underneath the cooler, such as plywood or a plastic mat, to prevent heat emissions from
ruining the carpet.
5. Make sure that legs are pressed firmly into the floor and allow the cooler to lean backward
slightly so that the doors remain closed.
DIGITAL THERMOSTAT
Manual
Defrost
Temperature
UP/DOWN
Light ON/OFF
LIGHT ON/OFF
To turn on the LED interior light, press the
the light.
ON/OFF POWER
To turn the beverage cooler ON or OFF, press and hold the
ADJUSTING TEMPERATURE
The temperature of the cooler can be controlled by the digital thermostat. The number
shown on the thermostat display correlates to the desired temperature.
To set desired temperature of the cooler:
1. Press the
SET
2. Use the
32°F - 72°F (0°C - 22°C).
3. Press again to complete the operation. You may also wait 5-10 seconds for the
SET
display to revert to showing the current internal temperature, and the new setting will
be saved.
'Defrost'
'Cooling'
Symbol
Symbol
Evaporator
Fan
button once. A 'beep' will sound and the display will start to flash.
buttons to set the desired temperature. This unit has a cooling range of
Interior Light
Symbol
Temperature
Alarm
button. Press the button again to turn off
key for 5 seconds.
Power ON/OFF
Celsius (C°) /
Fahrenheit (F°)
Set Button
8