Troubleshooting - melitta SOLO Manual Del Usuario

 Troubleshooting

Malfunction
coffee only runs
drop-by-drop
Coffee does not flow Water reservoir not
Grinder does not
grind coffee beans
Loud grinder noise
Bean symbols
are flashing although
the bean container is
filled.
the brew unit
cannot be re-inserted
after it has been
removed.

Heft_Solo_EU.indd 68
Cause
Grinding level too fine
filled or it is not inserted
correctly
Brew unit obstructed
Beans do not drop into
the grinder (beans are too
oily)
Foreign objects in the
grinder
Foreign objects in the
grinder
Insufficient quantity of
ground beans in the brew-
ing chamber
the brew unit is not cor-
rectly sealed.
the drive is not in the
correct position.
Measure
set the grinding level to a coar-
ser level
clean brewing unit
Decalcify if necessary
If necessary execute a cleaning
program
Fill water reservoir and ensure
that it is seated properly.
clean the brewing unit
tap lightly on the bean contai-
ner
contact the hotline
contact the hotline
Press the control button for
single-cup dispensing
two-cup dispensing
check whether the handle for
the locking mechanism is cor-
rectly locked in place.
switch the appliance OFF and
then ON again, then press the
operating buttons for single-
cup dispensing and two-cup
dispensing simultaneously for
more than 2 seconds. the drive
will move into position. Replace
the brew unit and check that it
is correctly locked in place.
or
09.07.2009 15:47:46