Installing The Sim Card - Erreka LINK-GSM Guía De Instalación, Configuración Y Uso

2
INSTALLATION, CONNECTIONS AND START-UP

Installing the SIM card

1 Ensure that the power supply is disconnected.
2 Insert the SIM card in its slot as shown in the figures.
3 Connect the electrical power supply. The LEDs flash
after a few moments.

First disconnect the power before extracting the
card.
General connections
12/14 VAC
PW
12/32 VDC
C
RL1
NO
C
RL2
NO
26
+5V
12 24
ST1 ST2
1 2 3 4 5 6 7 8 9 10 11 12
A
T
+5V
GND
Rxd
Txd

For safety reasons, the LINK-GSM system changes
the PIN number automatically.
Keep the PUK if you want to reuse the SIM in
another facility or for another application.

This layout shows how to connect the module
to use the RL1 and RL2 relays to activate any
device, provided the RL1 and RL2 limits are not
exceeded,
"Characteristics".
PW:
Power supply
12/24VAC or 12/32VDC
RL1, RL2:
Relay 1 and Relay 2 voltage-free contacts
C: common
NO: normally open
ANT:
Connection for outside antenna
A: active
ANT
T: earth
RS232:
Serial data connection for VIVO-D203, VIVO-
RS232
M203 and VIVO-M204 control boards
P256A
as indicated in the
I256A
section