When the SWITCH UNITS function is assigned to a function key and that key is pressed, the display
changes from the primary unit to the second unit. Pressing the function key again returns the
display to the primary unit. Each subsequent key press switches between display units.
When units are switched, the units indicator changes to show the selected unit, and the display
value is converted. The display division changes to an equivalent weight value in the switched unit
(for example, from 0.02 lb to 0.01 kg) and the decimal location switches to indicate the
conversion.
When switching units, the capacity of the converted units is dictated by the original number of
divisions established in the capacity and increments area of setup. In some situations, this may
reduce the capacity of the terminal when converting to second unit. If switching would result in a
value that is not supported by IND231/IND236, the unit switch will not occur.
1.4.3.
Date and Time
The Date & Time function key is only used to display date or time. Configure the Date & Time in
setup at F3 - Terminal > F3.3 - Date &Time. When the function key is first pressed, the time will be
shown. A second press displays the date. The third press returns the display to weighing mode. To
return directly to weighing mode at any time, press the CLEAR
1.4.4.
Backlight Adjustment
The Backlight Adjustment function key is used to set the brightness of the backlight. There are three
options: off, low and high. Each press of the key moves the backlight to the next setting.
1.4.5.
Zero
When a function key is set to ZERO, it has the same effect as the dedicated zero key
The Zero function is used to set or reset the initial zero reference point of the terminal. There are
three types of zero setting modes:
30100541
|
00
|
08/2013
Figure 1-7: Unit Switching: Kilograms to Grams
•
Automatic Zero Maintenance
•
Power Up Zero
•
Pushbutton Zero
.
METTLER TOLEDO IND231/IND236 Quick Guide
.
1-7