Safety Instructions - Hama 00040969 Manual De Instrucciones

Safety Instructions

Faults
• Make sure that the stereo reception control light
illuminates. If the control light does not illumina-
te, press the frequency selector on the speaker
until the control light illuminates.
• Select another frequency channel on the rear of
the transmitter. 2 channels are available. Press
the autotuning button on the speakers until no
extraneous noise is audible.
• The batteries / rechargeable batteries in the
speakers are too low. Please replace them.
• Make sure that the output signal set on your
playback device is loud enough.
• You have exceeded the distance between the
transmitting unit and speakers or there are too
many hindrances such as multiple steel-reinfor-
ced walls, metal covers, etc. between the trans-
mitter and speakers.
• The transmitter is directly next to another elec-
trical transmitter source such as a wireless tele-
phone, microwave oven, computer, etc. Increase
the distance between the devices.
We strive to continually improve all types and
models. Therefore, please bear in mind that the
form of the scope of delivery, equipment and tech-
nology are subject to change at all times. Therefo-
re, no claims can be derived from the specificati-
ons, illustrations and descriptions in this manual.
This manual may not be reprinted, reproduced or
translated in part or whole without prior written
consent from the manufacturer. The manufacturer
reserves all rights.
Subject to changes.
Safety instructions:
1. Keep away from dirt and moisture and avoid
overheating. Only use in dry rooms.
2. Do not open up appliance. If appliance becomes
damaged, do not continue to use.
Only allow specialists to repair device!
3. Only use dry, soft cloths for cleaning purposes.
4. Caution! Keep these speakers, as with all elec-
trical devices, out of the reach of children
5. Keep away from direct sunlight, radiators and
vibrations. Protect from dust.
6. If you do not intend to use the appliance for a
long period, disconnect from mains.
7. The transmitter and receiver are designed for a
220-240V AC/50Hz mains supply.
9