WEG CFW500 Guía De Instalación, Configuración Y Operación página 8

Ocultar thumbs Ver también para CFW500:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation, Configuration and Operation Guide
Table 1: Settings of switches to select the type of analog input and output of the CFW500-CUSB
Input / Output
Signal
Voltage
AI1
Current
Voltage
AO1
Current
Table 2: Settings of switches for configuration of the RS485 and USB in the CFW500-CUSB
Communication Switch
RS485
USB
S2
(*) Any other combination of switches is not allowed.
The USB communication of this module presents the following features:
Interface with the computer: USB V2.0 Plug and Play.
Plug-in mini USB connector (mini-B – see figure A.2).
Firmware recording of the main processor via FDT (available on the CD-ROM). With
the de-energized inverter, the DIP-switch S2 must be set as in table 2.
Parameter setting and programming of the SoftPLC (WLP program). The indications
of alarms, faults and communication status is done through HMI and product
parameters. For more details see the manual of the softPLC.
Superdrive.
ATTENTION!
With the switches S2.1=ON and S2.2=ON the inverter is putting on the
firmware recording mode. This operation should only be done with WEG's
agreement. Improper use of this operation may damage the inverter.
8 | CFW500-CUSB
Setting of switch S1
S1.1 = OFF
S1.1 = ON
S1.2 = ON
S1.2 = OFF
Setting of switches
S1.3 = OFF and S1.4 = OFF Termination RS485 OFF
(*)
S1
S1.3 = ON and S1.4 = ON Termination RS485 ON
S2.1 = OFF and S2.2 = OFF USB in normal communication mode
(*)
S2.1 = ON and S2.2 = ON USB in firmware recording mode
Range of signal Parameter settings
0...10 V
0...20 mA
4...20 mA
0...10 V
0...20 mA
4...20 mA
- English -
P0233 = 0 or 2
P0233 = 0 or 2
P0233 = 1 or 3
P0253 = 0 or 3
P0253 = 1 or 4
P0253 = 2 or 5
Option

Publicidad

Tabla de contenido
loading

Tabla de contenido