Radio Self-Learning (Dip1:OFf); Transmitter Remote Learning; Led Diagnostics; Fuses - Beninca MS5 Manual De Instrucciones

23) RADIO SELF-LEARNING (DIP1:OFF)

The CP.MS5 control unit is equipped with a built-in radio module for the reception of Rolling Code ARC remote controls, with a frequency
of 433.92MHz.To use a remote control, it is first necessary to store its code in memory. The memorisation procedure is described here-
under. The device is able to store up to 64 different codes in memory.
By pressing P1, the control unit enters the radio learning phase: DL1 red LED flashes 1 time per second, awaiting the key to the matched
to the Step-by-Step function;
When the key is stored in memory, exit from the programming mode;
By pressing P1 twice, the DL1 red LED flashes 2 times per second and the pedestrian learning phase is entered (the pedestrian function
controls an opening operation of 7s).
When the key to be matched is memorised, exit from the programming mode.
If the programming mode must be left without storing any remote control signal, press P1 key until DL1 red LED starts to flash in "power
on" mode (see LED diagnostics).
To reset the memory of the receiver, press and keep P1 and P2 keys pressed for around 10 seconds (during this period of time, both
DL1 and DL2 flash rapidly).
After 10 seconds, when the two LEDs are switched on with fixed light, release the push-buttons.
When the LEDs switch back again to the original configuration, the control unit has completed the memory reset.
NOTE:
The transmitters are memorised on an EPROM memory (U3), which can be extracted from the control unit and inserted in a new CP.MS5
control unit should a replacement is required.
For safety reasons, the transmitters can be stored in memory during the opening/closing of the motor.

24) TRANSMITTER REMOTE LEARNING

If the transmitter code is already stored in the receiver, the remote radio learning can be carried out (without accessing the control unit).
IMPORTANT: The procedure should be carried out with gate in the opening phase, during the TCA dwell time.
Proceed as follows:
1 Press the hidden key of the transmitter, the code of which has already been stored in memory.
2 Within 5 seconds, press the already memorised transmitter key corresponding to the channel to be
matched to the new transmitter. The flashing light switches on.
3 Within 10 seconds, press the hidden key of the new transmitter.
4 Within 5 seconds, press the key of the new transmitter to be matched to the channel selected at item 2.
The flashing light switches off.
5 The receiver stores the new transmitter code and exits from the programming mode immediately.

25) LED DIAGNOSTICS

The red LED DL1 indicates the activation of inputs according to the legend hereunder:
STOP on with fixed light
PHOT rapid flashing
SWO 1 flash with 2-second interval
SWC 2 flashes with 2-second interval
By flashing slowly, the red LED DL1 also indicates that the unit is powered.
The green LED DL2 indicates the movement direction of the motor and the status of the gate according to the legend hereunder:
OPENING
CLOSING
Open gate without TCA
Open gate with TCA
Closed gate

26) FUSES

MS5 230Vac: F2 = T100mA
MS5 115Vac: F2 = T200mA
1 blinking per second
2 more than one blinking per second
on with fixed light
rapid flash
LED off
F3= F6,3A
F3 = F10A
EN
21