Programming; Basic Programming; Advanced Programming - Aprimatic PTR-24 Instrucciones Para La Instalación Electrica, El Uso Y El Mantenimiento

CONTROL UNIT
4.

PROGRAMMING

IMPORTANT! The barrier must be stopped and closed before you can start programming.
In order to save your settings you must complete and confi rm your settings and then leave the programming function. The display will
switch off. If the power supply fails for any reason during programming, all the modifi cations you have made will be lost.
IMPORTANT: All input signals will be ignored during programming.
MAN
Note: If the message appears and fl ashes for 3 seconds when you enter the programming mode, this indicates
that you must complete the scheduled maintenance before proceeding.
4.1

BASIC programming

See the fi gure below.
Press and hold R e l e a s e t h e
the RED button button
PROC
f i r s t l e t t e r s
until " " is
identifying the
shown on the
programmable
display.
parameters are
displayed.
PROC
RED RED
YELLOW
Press the YELLOW button to exit
and return to normal functioning:
the displays are switched OFF.
4.2

ADVANCED programming

Complete steps 1 and 2 of Basic programming and then proceed with Advanced programming as shown in the fi gure below.
P r e s s t h e
BLUE button to
Press the RED but-
scroll through
ton to access ad-
the parameters
vanced program-
PRoF
until " " is ming and show the
shown on the parameters.
display.
ProF
BLUE
ESC
YELLOW
Press the YELLOW button to exit
and return to normal function-
ing: the displays are switched
OFF.
Press the BLUE
the button to scroll
t h r o u g h t h e
programmable
parameters.
LO.0
BLUE
ESC
P r e s s t h e
BLUE button to
scroll through
the advanced
parameters.
A4
A3
A1 A2
RED BLUE
YELLOW
Press the YELLOW button
to return to step
PTR-24
Press the RED
b u t t o n w h e n
a parameter is
shown to display
the current setting
(marked by the
dot).
O.
RED
If you decide not to make any modifi cations,
press the yellow button
parameters again (step
P r e s s t h e
P r e s s t h e RED
BLUE button
button when the
a n d s c r o l l
parameter to be
through the
modifi ed is shown
values avail-
and the value set is
able for the
shown (highlighted
parameter.
by the dot).
00.
RED BLUE
ESC
this parameter starting from step
.
programming by pressing the YELLOW button repeatedly
until the displays are switched OFF.
- 26 -
Press the Press and hold the RED
BLUE but- button for 3 seconds to
ton to scroll select the value required
t h r o u g h 3 flashes confirm
the values that the new setting has
a v a i l a b l e been saved. Release the
for the pa- RED button and press
rameter. the YELLOW button to
show the next parameter.
2
BLUE RED
ESC
YELLOW
to display the
).
Press the RED button
when the value required
is shown to make modi-
fi cations 3 fl ashes con-
fi rm that the value has
been saved. Release
the RED button.
00
01
RED
Press the YELLOW
button to display the
ESC
next programmable
parameter. Program
YELLOW
or exit advanced
2.