Faber CAMINO PRO Serie Instrucciones De Instalación página 26

Cleaning metal grease filters
The metal grease filters can be cleaned in hot detergent
solution or washed in the dishwasher. They should be
cleaned every 2 months, or more frequently if use is
particularly heavy.
• Install the grease rail into the back of the hood, into
the slots on the inside floor of the rear of the hood
• The grease filters should be installed before operating
the rangehood.
• To install the filters, use the two knobs to hold the filter
and insert the filter into the front edge of the hood
with the knobs facing out into the spring loaded slot.
Install the other end of the filter above the grease rail
in the back of the hood.
• No water can be present in filters before installing
back in hood.
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable
and cannot be regenerated, and should be replaced
approximately every 4 months of operation, or more
frequently with heavy usage.
• Remove the charcoal filter by rotating it clockwise (
backwards) until it unlocks from the motor housing and
pull off sideways.
• To re-insert each charcoal filter, place up against
the side of the blower and push it inward. Then
turn the charcoal filter clockwise (forward) until it
fits into place.
"When used in recirculation mode, to
Caution:
Reduce the Risk of Fire and Shock use only conver-
sion kit Model FILTER 1 or FILTER1LL".
Lighting unit
• Remove the snap-on lamp cover
by levering it from under the metal
ring, supporting it with one hand.
• Replace the lamp with a new one
of the same type, making sure that
you insert the two pins properly into
the housings on the lamp holder.
• Replace the snap-on lamp cover.
26
1
2
A
B
Gu10 self-ballasted led
lamps – listed in ac-
cordance with
ul 1993/nmx-
j-578/1-ance/
csa c22.2 No.
1993