Connection Battery Connector And Switching On Of The Machine; Batteries Charge Level Indicator; Hour Meter; Squeegee Assembly - Tornado BR 40/66 Manual Del Usuario

CONNECTION BATTERY CONNECTOR
AND SWITCHING ON OF THE MACHINE
Once the battery recharging has been
completed:
1. Disconnect the connector of the battery
charger from the battery connector (1).
2. Connect then the battery connector (1)
to the machine connector (2).
To start any function of the machine, it
is necessary to rotate clockwise the key
switch (5). Rotating it counterclockwise
any function will be switched off.
BATTERIES CHARGE LEVEL INDICA-
TOR
WHEN THE MACHINE IS SWITCHED
ON, ON THE DISPLAY (1) APPEAR
IN ORDER THE FOLLOWING INFOR-
MATION:
1. the version (for example A003) of soft-
ware installed on the machine.
2. the setting of the battery check card
which can be:
GE 36: check card set for GEL batteries.
or
Pb 36: check card set for lead batteries.
3. The batteries charge level indicator is
digital and remains fixed on the display.
The battery charge level starts from 100,
which indicates the 100% of the total
charge and decreases by 10 to 10. When
the charge level reaches 20%, the display
starts blinking, so you are about the end of
working.
ATTENTION:
After a few seconds of the indication 10%
and after this, the blinking of the four lines,
all the functions stop automatically. With
the remaining charge it is anyhow pos-
sible to finish the drying operation before
proceeding to the charge station.

HOUR METER

The machine is equipped with an hour
meter located on the same display (1) of
the battery charge level indicator. Pressing
the button (2), the first data indicates the
working hours and after a few seconds the
working minutes are shown.
11

SQUEEGEE ASSEMBLY

1. Insert the two screws (3) situated on the
upper part of the squeegee (2) inside the
slots present on the support.
2. To block the squeegee tighten the stud
bolts (3).
3. Insert the squeegee hose (4) into its
coupling, respecting its position as indi-
cated in the figure.

ADJUSTMENT OF THE SQUEEGEE

In order to have a perfect drying result
through the squeegee, the rear rubber
must have the lower bending uniformly ad-
justed in all its length. For the adjustment,
the suction motor has to be switched on
and the brushes have to function together
with the detergent solution.
If the lower part of the rubber is bent too
much
Take off the pressure rotating the wing nut
(5) counterclockwise.
If the lower part of the rubber is not bent
enough
Increase the pressure rotating the wing nut
(5) clockwise. Check that the wheels which
adjust the height do not rest on the floor,
in this case adjust them as indicated in
paragraph "Height adjustment".
If the bending is not uniform
Adjust the squeegee inclination rotat-
ing counter-clockwise the wing nut (6) to
increase the bending in the central part, or
clockwise to increase the bending on the
ends.
Height adjustment
Once the pressure and inclination of the
squeegee have been adjusted, it is neces-
sary to fix this optimum condition and
make the wheels slightly touch the floor.
Rotate clockwise the registers (7) to lower
the wheels or counterclockwise to raise
them. Both wheels must be adjusted the
same. To act upon the register (7) loosen
at the same time the two milled ring nuts,
adjust the height acting on the upper one
and then fix the adjustment screwing and
blocking the lower one.