Tools Needed - Danby DAC10000 Guía A Utilizar Y Cuidar Del Proprietario

Installation Instructions
HOW TO
INSTALL
* See www.danby.com for
video instructions.
WARNING
When handling unit, be careful to
avoid cuts from sharp metal edges
and aluminum fins on front and rear
coils.
NOTE: Top Rail and Sliding Panels at each side are offset to provide the
1
proper pitch to the rear of (5/16"). This is necessary for proper condensed
water utilization and drainage. If you are not using the Side Panels for
any reason, this pitch to the rear must be maintained to allow water build
up in humid conditions to drain outside.
A. Place unit on floor, a bench or a table. There is a Left and Right
Window Filler Panel - be sure to use the proper panel for each
side.When installed the flange for securing the panel in place to the
window sill will be facing into the room.
Hold the accordion panel and gently pull out past the open end of the
frame. See Figure 2.
Fig. 2
B. Slide the free end ("I"section) of the panel into the cabinet as shown in
Figures 3A, 3B & 4. Slide the panel down. Be sure to leave enough
space to slip the top and bottom of the frame into the rails on the
cabinet.
Fig. 3B
5

TOOLS NEEDED

• Phillips Screw Driver
• Drill (If pilot holes are needed)
Fig. 3A
Fig. 4