GOLDONI 3000 STAR Serie Manejo Y Cuidado página 69

the battery clean and store it in a dry place if it is to remain unused for a long period
of time.
- Clogging gauge of the engine air filter
Check that the clogging gauge of the engine air filter is in the correct position and, if
it is serviced, make sure that it is correctly assembled and protected against the
outdoor weather conditions as indicated in fig. 33.
It is essential for the cable connecting to the electrical system of the machine N° 1
fig.33 to come out of the lower part of the actual gauge itself. The engine air intake
circuit could be seriously damaged if the protection is installed in the wrong position.
- Fuses:
Before changing a fuse, eliminate the fault that caused it to blow. The fuses protect
the following circuits (fig.29):
A= Power supply for the rotating beacon switch (7.5A)
B= Parking brake switch (brake light), turning indicators and hazard light switch, cab
connector (15A)
C= Rh front / lh rear side light, 8-way male connector pre-engineered in cab, 7-pin
power socket (10A)
D= Lh front / rh rear side light, registration plate light, 8-way male connector pre-
engineered in cab, control panel lighting, 7-pin power socket connector, cab
connector (10A)
E= Power supply for motor stop solenoid valve, preheater energizing, PTO switch,
control panel, diff lock switch (7.5A)
F= Power supply for 8-way male connector pre-engineered in cab (7.5)
G= Lh lower beam (10A)
H= Rh lower beam (10A)
I = Auxiliary power socket (20A)
L= Power supply for horn, 7-pin power socket (10A)
M= Power supply for cab connector, turning indicators and hazard light switch, main
beam blinker function, cab connector (15A)
N= Rh / lh main beam light and main beam indicator (15A)
The tractor has a main 60A knife-blade fuse situated in the internal part of the fixed
bonnet (3 pcs fig. 30). This fuse protects the entire electrical system.
68