Introduction; Panel Indicators & Controls; Indicators - Notifier EN54 Manual De Usuario

EN54 2-8 Zone Conventional Fire Panel - User Manual
1

Introduction

Only authorised and suitably-trained personnel must carry out
procedures in response to fire alarm events or perform scheduled
test and maintenance activities.
This manual contains operating instructions for the EN54, 2 - 8 zone conventional
fire control panel. All the control and operation functions described in this manual
can be carried out using the pushbuttons on the front of the panel.
Users of this manual are assumed to be working with a panel that has already
been installed and configured appropriately for the area under its supervision.
2 Panel Indicators and Controls
The panel's indicators display the panel status and the controls are used to operate
the overall system. The panel has up to eight zonal LED indicators, a 'FIRE'
indicator, thirteen system status LED indicators and eight function pushbuttons.
2.1

Indicators

The location of the panel's indicators is shown below:
FIRE - The following red status indicators are provided:
General Fire and 8 Zone Fire LEDs
FAULT - The following yellow status indicators are provided:
Fault /Disabled /Test and 8 Zone Fault /Disable /Test LEDs
SYSTEM - The following 13 status LEDs are provided:
Power available - mains and/or battery ................................................... G
General Fault; General Disablement; General Test; Delay On (active); System
Fault; Earth Fault; Power Supply Fault; Sounder Fault /Disabled; Fire Routing
Fault /Disabled; Fault Routing Fault /Disabled; Auxiliary Fault ........................ Y
Fire Brigade Called /Fire Routing Output Active ...................................... R
Note:
Yellow LEDs:
Red LEDs:
Flashing - Fault; Steady - Disablement.
Flashing - New alarm; Steady - Accepted alarm.
1 997-493-002-2, Issue 2