JMA MULTICODE DUPLA Manual De Uso página 85

MULTICODE DUPLA
KEY CUTTING MACHINE
After having erased the Flash memory of the machine a process bar will appear with the following:
The updating process will take 30 minutes Once the progress bar has reached its end. A message will appear for us
to switch the machine off and on.
After the downloading process has finished, the above message appears, we can exit the "JMAKeyPro" application
pressing the button END (F). We switch off the MULTICODE DUPLA machine and then switch it on again, we will see
the green diode flash, that is because the firmware program is updating. This is normal and the process will take from
5 to 10 minutes, until the diode becomes steady green, at that moment the MULTICODE DUPLA is prepared to enter
the application again and continue cutting keys.
85