Leister SEAMTEK W-900 AT Instrucciones De Servicio página 41

209 2 Error 209: Can not open Backup Destination
File.
210 2 Error 210: Can not read Backup Source File.
211 2 Error 211: Can not write Backup Destination
File.
212 2 Error 212: Can not close Backup Destination
File.
213 2 Error 213: Can not close Backup Source File. Recipe File on PLC (SPS) corrupted.
214 2 Error 214: Can not open Recovery Source
File.
215 2 Error 215: Can not open Recovery Destina-
tion File.
216 2 Error 216: Can not read Recovery Source
File.
217 2 Error 217: Can not write Recovery Destina-
tion File.
218 2 Error 218: Can not close Recovery
Destination File.
219 2 Error 219: Can not close Recovery Source
File.
220 2 Error 220: Open File in Read Machine
Settings
221 2 Error 221: Read CSV Line in Read Machine
Settings
222 2 Error 222: Close File in Read Machine
Settings
223 2 Error 223: X-Axis Error from Controller
224 2 Error 224: Y-Axis Error from Controller
225 2 Error 225: UPWM-Axis Error from Controller.
226 2 Error 226: Error UPWM-Axis. Busy during
WpAbs-State. INOUT_SMALLSTEP.
227 2 Error 227: Error UPWM-Axis. Busy during
WpAbs-State. IN_ABSOLUT
228 2 Error 228: Error UPWM-Axis. Busy during
WpPush-State
Missing Memory Stick.
Recipe File on PLC (SPS) corrupted.
Do recover your Data from your Memory.
Missing Memory Stick.
Missing Memory Stick.
Do recover your Data from your Memory.
Recipe File on Memory Stick corrupted.
Do backup your Data from PLC (SPS) to
Memory Stick.
Recipe File on PLC corrupted.
Recipe File on Memory Stick corrupted.
Do backup your Data from PLC (SPS) to
Memory Stick.
Recipe File on PLC (SPS) corrupted.
Recipe File on PLC (SPS) corrupted.
Recipe File on Memory Stick corrupted.
Do backup your Data from PLC (SPS) to
Memory Stick.
In SettingsRead()
Error Machine Settings Open File. All Pass-
words set to Standard
InSettingsRead()
Error Read CSV Line Machine Settings
In SettingsRead(), Error Closing File
In ErrCheck()
check if parameter settings are correct or
X-Axis is mechanically blocked, check Aham
right enable setting
In ErrCheck()
check if parameter settings are correct or
Y-Axis is mechanically blocked
In ErrCheck()
check if parameter settings are correct or
UPWM-Axis is mechanically blocked
In UPWM_AxisWPush()
Movement not possible, UPWM-Axis is alrea-
dy operating
41