Installation Of Guide Section Bar; Installation Of Motor On Section Bar; Installation - DIMOEL DIMO 700 Manual De Instrucciones

INSTALLATION OF GUIDE SECTION BAR

1. Remove the section bar from its cardboard packaging and
check its integrity.
2. Unfold the section bar as indicated in the figure below.
3. Once the section bar is elongated, slide the connecting
section bar to the end position indicated by the two C shaped
holes on the chain-guide section bar.
C Shaped hole
4. Adjust the tension of the chain using the Allen-head screw
with a 10 mm Allen-wrench: turn the bolt until the chain is
sufficiently tight.
CAUTION: Make certain that the draw slide slides
freely along the entire length of the guide. Eliminate any
friction prior to proceeding with the next phases of

installation.

C Shaped hole
Connecting Section Bar
12

INSTALLATION OF MOTOR ON SECTION BAR

1. Insert the shaft/pinion adapter on the motor shaft.
2. Position the section bar on the motor: The shaft/pinion
adapter must fit into the seat on the section bar. Verify that
the section bar fits snuggly against the motor.
3. Position the two omega brackets on the section bar so that
they correspond with the holes on the base of the motor.
4. Fasten the two omega brackets using the 6 x 15 self-
threading screws provided.
Screws 6x15
Omega Bracket
Micro switch
INSTALLATION
2.1 Disassemble the door's locking system.
2.2 Measure the door, and at exactly half its height mark the
reference points on the upper crossbeam and on the
ceiling to facilitate positioning of the guide section bar.
Section Bar
Shaft/Pinion
Adapter