Troubleshooting - NuWave OxyPure Manual Del Usuario

CARE & MAINTENANCE (Continued)
Do not immerse the OxyPure in water.
Clean with a damp sponge or cloth and wipe dry.
Make sure all parts and covers are
securely attached.
Problem:
Unit does not turn on.
TIMER does not work
when pressed.
The fans are
not blowing.
Speed of the airflow is
not changing
when "FAN SPEED"
is pressed.
Airflow out of Top Vent
is weak.
Unit is producing
smoke or odor.
CLEAN and
REPLACE FILTER
Indicators have not
reset after filter(s) has
been cleaned
or changed.
22
Owner's Manual

TROUBLESHOOTING

1. The plug is not in the wall outlet. Plug into wall outlet.
2. "Power" on touchpad panel is not on. Press "Power".
3. The Filter Slot Cover in the back rear is off or
loose. Make sure Filter Slot Cover is on securely.
The unit is not reading the function selected.
Press "FAN SPEED" or "AUTO", then press "TIMER".
1. An appropriate outlet is not being used. Make
sure outlet has appropriate voltage for use.
2. The Filter Slot Cover in back rear is not properly in
place. Make sure Filter Slot Cover is on securely.
Unit may be in manual AUTO mode. Set the OxyPure
to other operating mode on the touchpad then press
"FAN SPEED".
Air filter(s) are dirty. Change or clean the air filters.
Air filter(s) are dirty. Change or clean the air filters.
If problem continues, contact Customer Service at
1-877-689-2838 or email help@nuwavenow.com.
1. The Filter Sensor is not reading the new filter
installed. Turn unit off then turn on. Press and hold
down "TIMER" for 2 seconds until a beep is heard.
2. Turn unit off, unplug and adjust filter(s). Plug in
and turn the unit ON again.
3. The Filter Slot Cover in back rear is not securely in
place. Make sure Filter Slot Cover is on securely.
4. The Filter Sensor is dirty. Clean the Filter Sensor.
Solution(s):