Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.5. Installation of the pH/ORP sensor
1.
Insert the pH and ORP sensors into their corresponding places of the holder (Fig. 12)
2.
Loosen the connection screws and insert the sensor into the holder.
3.
The sensors must be installed in the holder so that it is guaranteed that the sensors located in their ends are always submerged in
the water circulating through the pipe.
4.
Always install the sensors vertically or with a maximum inclination of 40
Fig. 12
4.6 Cover detaching
1.
Remove the embellisher (A) situated in the cover.
2.
Unscrew the cover fixation screw (B).
3.
Remove the cover by sliding it upwards and outwards.
o
(Fig. 13).
7
Fig. 13
Publicidad
Tabla de contenido
