Measurement; Parameter Interface - Gima SP-10 Manual Del Usuario

13

6.1.2 Measurement

1) Long press "Power On" key to turn on the power after installed.
2) The device is in selective interface after turn on as Figure 6-1, press "Up", "Down" key to adjust, select "No" to
"Testing" interface as Figure 6-2.
3) Then breath in fully and seal the lips around the mouthpiece and blast all air out as forcefully as possible in best
times, wait for a few seconds, then the data will be gained, measure is over (Note: "Yes" indicates that you can
edit patient information, exit after edit, or return to "Testing" interface, the detail operations are as following).

6.1.3 Parameter interface

In testing interface, breath in fully and seal the lips around the mouthpiece and blast all air out as forcefully as pos-
sible in best times, wait for a few seconds, then the measured parameter will pop up automatically as Figure 6-3.
Figure 6-1
ENGLISH
Figure 6-2