Lutron GRAFIK Eye QS System Manual De Instrucciones página 32

Troubleshooting (continued)
Symptom
Unit does not allow scene change or
zone adjustments
Screen is off
Occupant sensor input does not work
Timeclock events do not occur
Sunrise or sunset events do not occur at
the correct time
R
Possible Causes
Unit in wrong save mode
Keypad in system has locked the unit
Normal operation
Miswire
Incorrect programming
Input closure/opening is not occurring
Timeout on occupant sensor is set too
long
Timeclock is disabled
Time is not set correctly
Date is not set correctly
Location is not set correctly
Holiday schedule is in effect
GRAFIK Eye
Remedy
Change to correct save mode
Check programming and state of
keypads
Screen turns off after 20 seconds
Check wiring on contact closure input
Re-program the occupied and
unoccupied states of the input
Check that the input device is opening
and closing properly
Set the occupant sensor timeout to a
shorter time
Enable the timeclock
Set the time
Set the date
Set the latitude and longitude correctly
Remove the holiday schedule from your
programming
QS System Installation and Operation Guide 32
®