Hoshizaki FM-170EE-HC Manual De Instalación página 4

1. UNPACKING
Children should not be allowed in reach of
the packaging elements (plastic bags and
expanded polystyrene) as they are potential
sources of danger.
1. Do not lift or manoeuvre the carton by using
the shipping bands.
2. R e m o v e s h i p p i n g c a r t o n , t a p e ( s ) a n d
packing. If packing material is left in the
icemaker, it will not work properly.
Front Panel
(Left)
Power Supply
Cord
1) After removing the packaging, make sure that
the icemaker is in good condition. If in doubt,
please do not use the equipment but apply to
professionally qualified personnel.
2) Remove the shipping tape holding the door and
front panel.
3) Open the door, take out the package containing
accessories, and check the contents:
a) Installation Kit
Inlet Hose
Outlet Hose
Adjustable Leg
b) Scoop
4) Remove the front panel (left) and top panel. See
Fig. 2.
5) Remove the protective plastic film from the
panels. If the icemaker is exposed to the sun or to
heat, remove the film after the icemaker cools.
WARNING
CAUTION
Top Panel
Air Filter
Fig. 1
1
1
4
1
Front Panel
(Left)
Front Panel (Left): Remove the screws. Lift up and
Top Panel:
2. LOCATION
Door
1. This icemaker is not intended for outdoor
use. Normal operating ambient temperature
Front Cover
s h o u l d b e w i t h i n 5 ° C t o 4 0 ° C . Wa t e r
connection is cold water only. Operation of
the icemaker, for extended periods, outside
of these normal temperature ranges may
affect production capacity.
2. The icemaker should not be located next to
ovens, grills or other high heat producing
equipment.
3. The location should provide a firm and level
foundation for the equipment.
4. Allow 15 cm clearance at rear, sides and
top for proper air circulation and ease of
maintenance and/or service should they be
required.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. Do not place anything on top of the icemaker
or in front of the louver.
7. This icemaker will not work at subfreezing
temperatures. To prevent damage to the
water supply line, drain the icemaker when
air temperature is below zero (see "II. 2.
PREPARING THE ICEMAKER FOR LONG
STORAGE" in the instruction manual).
3
ENGLISH
Top Panel
Protective
Plastic Film
Adjustable Leg
pull toward you.
Remove the screws and lift up.
Fig. 2
IMPORTANT