Maintenance Activities - Holmatro GBP10EVO3 Manual Del Usuario

EN
/i
Hydraulic couplers
Battery
On/off switch and
cable
Pump
1. The equipment must be thoroughly inspected, checked, set and tested. We recommend hav-
ing this extensive maintenance performed by the Holmatro dealer (see also section 1.5).
8.5

Maintenance activities

8.5.1 General
• After every use:
1. Check the battery pack for damage and function.
2. If the battery pack is damaged or does not function correctly, replace the damaged battery pack.
3. Check the operation of the tool.
4. Check the tool for damage and leaks. If the tool does not work properly and/or leaks, have it
repaired by a Holmatro Certified Technician.
8.5.2 Hydraulic couplers
• Check the couplers for damage. Have a Holmatro Certified Technician replace damaged couplers.
• Clean the coupler with lukewarm water and a mild soap solution.
• Dry the couplers.
• Lubricate the end of the coupler with hydraulic oil or inject WD-40.
• Lubricate the locking ring by injecting WD-40 into the space between the back section and the
locking ring.
• Connect the couplers and check whether the coupler locks automatically. Check the locking by
pulling the hoses apart with a normal manual effort. The couplers must not slip.
• Disconnect the couplers by turning the locking ring and pulling it backwards.
• Connect and disconnect the couplers a few times to improve the internal lubrication of the locking
system.
44
Check
Clean / Lubricate
Check
Recharge
Check
916.400.220_001
Time interval
x
x
x
x
x
GBP10EVO3