Changing The Batteries; Storage - Crane AU5-CDSC-1 Manual Del Usario

36
USA

Changing the batteries

If you stand on the scale and "Lo" appears on the display
instead of the measurements, the batteries are no lon-
ger supplying sufficient power.
If you stand on the scale and nothing appears on the
display, the batteries are empty. To change the batteries,
proceed as follows:
1. Place the scale on a soft base with the bottom facing
up.
2. Open the battery compartment
3. Take the batteries
compartment.
4. Insert new batteries in the battery compartment. Use
batteries of the same type.
The polarity is correct if the negative poles of the
batteries are lined up with the corresponding spring
contacts in the battery compartment.
5. Close the battery compartment.
6. Turn the scale over.
The reading "0.0" will appear on the display.
7. If nothing appears on the display, remove the batter-
ies and insert them again.

Storage

If you do not use the scale for a prolonged period of
time, please observe the following notes:
4
3 out of the battery
Storage
(see fig. B).