Battery Charging; Brake Adjustment; Seat Adjustment; Mower Adjustments - Gauge Wheels - Simplicity Regent Serie Manual Del Operador

Troubleshooting &Adjustment

Battery Charging

WARNING
Keep open flames and sparks away from the
battery; the gasses coming from it are highly
explosive. Ventilate the battery well
during charging.
A dead battery or one too weak to start the engine may be the
result of a defect in the charging system or other electrical
component. If there is any doubt about the cause of the
problem, see your dealer. If you need to replace the battery,
follow the steps under Cleaning the Battery & Cables.
To charge the battery, follow the instructions provided by the
battery charger manufacturer as well as all warnings included in
the safety rules sections of this book. Charge the battery until
fully charged. Do not charge at a rate higher than 10 amps.

Brake Adjustment

This unit does not have a manually adjustable brake. If brake
does not function properly see your dealer.

Seat Adjustment

The seat can be adjusted forward and back. Move the lever (A,
Figure 12), position the seat as desired, and release the lever to
lock the seat into position.
Figure 12. Seat Adjustment
A. Seat Adjustment Lever
A
24
Mower Adjustments
Gauge Wheels (Select Models)
The mower gauge wheels can be placed in two positions
depending on the height of cut. When using higher cutting
heights, set the wheels in the lower position. When using lower
cutting heights, set the wheels in the upper position. Do not
allow wheels to remain on the ground constantly while mowing.
To adjust:
1. Remove the locknut (B, Figure 13), gauge wheel (C),
washers (D), and shoulder bolt (E). Change position of
gauge wheel to desired height.
2. Insert shoulder bolt (E) through washers (D) gauge wheel
(C), and gauge wheel bracket (A). Secure with locknut (B).
Repeat Steps 1 & 2 for all gauge wheels.
B
C
Figure 13. Fixed Bracket Gauge Wheel
Adjustment
A. Gauge Wheel Bracket
B. Locknut
C. Gauge Wheel
D. Washer
E. Shoulder Bolt
A
D
E