Assembly; Unpack Pressure Washer; Attach Handle; Add Engine Oil - Briggs & Stratton PRO Serie Manual Del Operador

Assembly

Read entire operator's manual before you attempt
to assemble or operate your new pressure washer.
Your pressure washer requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your pressure
washer, please call the pressure washer helpline at
(800) 743-4115. If calling for assistance, please have model,
revision, and serial number from data tag available.

Unpack Pressure Washer

1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensure you have all included items prior to assembly.
Items in the carton include:
• Main Unit
• Handle
• Quick Connect Spray Gun
• Nozzle Extension
• Detergent Nozzle with
Detergent Siphoning Tube/Filter
• Turbo Nozzle
• High Pressure Hose
• Oil Bottle(s)
• Safety Goggles
• Operator's Manual
• Owner's Registration Card
• 4 Multi–Colored Spray Tips
To prepare your pressure washer for operation, you will
need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle to main unit
.3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and pump.
6. Attach spray gun and nozzle extension.
7. Connect water supply to pump.
8. Select/attach quick connect spray tip to nozzle
extension.
8

Attach Handle

1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with
holes on handle supports.
C
NOTE: It may be necessary to move the handle supports from
side to side in order to align the handle so it will slide over
the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach a plastic knob from inside of unit. Tighten by
hand.
3. Insert multi-colored quick connect spray tips and other
supplied accessories in spaces provided on handle.

Add Engine Oil

1. Place pressure washer on a flat, level surface.
2. Clean area around oil fill and remove yellow oil fill
cap /dipstick.
NOTE: See Oil Recommendations in Maintenance section.
Verify provided oil bottle is the correct viscosity for current
ambient temperature.
3. Using oil funnel (optional), slowly pour contents of
provided oil bottle into oil fill opening to the "Full"
mark on dipstick. DO NOT overfill.
NOTICE
Improper treatment of pressure washer can damage it and
shorten its life.
• DO NOT attempt to crank or start the engine before it has been
properly serviced with the recommended oil. This may result in
an engine failure.
4. Replace oil fill cap and fully tighten.
5. Change oil after first 5 hours of operation. See
Maintenance Schedule for more information.
A
B
BRIGGSandSTRATTON.COM