Line Terminal; Video Door Phone Code; Example Of Configuration; Installation Completion - Urmet 1722/81 Manual De Instrucciones

7.2.

LINE TERMINAL

Jumper JP1 is present on the video door phone, on the right of the terminal board, and allows to insert the line terminal. The line terminal must be
activated on the video door phone connected to the end of a line which is not resumed with another segment from the same terminal (LINE).
The position of jumper JP2 must not be varied.
7.3.

VIDEO DOOR PHONE CODE

Set the respective address using the dip switches on each apartment station to install "slave" video door phones.
Address
"Master" video door phone
"slave" 2 video door phone
7.4.

ExAMPLE OF CONFIGURATION

BASIC KIT
B
2
To rest
of the system
Line
terminal ON
ON
Master
1 2
7.5.

INSTALLATION COMPLETION

To complete installation, fix the video door phone to the bracket as shown in the following drawing and remove the transparent film.
DS17-06A
Terminal not inserted
Terminal insert (default)
Dip switch position
ON
1 2
ON
1 2
WITH FOUR VIDEO DOOR PHONE IN PARALLEL
To rest
of the system
1
2
JP1
Address
"slave" 1 video door phone
"slave" 3 video door phone
B
Line
terminal OFF
2
ON
Master
1 2
2
OP3
Dip switch position
ON
1 2
ON
1 2
Line
terminal OFF
ON
Slave n°1
1 2
2
OP3
Line
terminal OFF
ON
Slave n°2
1 2
2
OP3
Line
terminal ON
ON
Slave n°3
1 2
1