Tornado 97560T Manual De Instrucciones página 10

STOPPING ENGINE
1. Lower the engine speed to an idle, and allow the engine to idle for about one minute.
2. Turn fuel valve on tank to the closed position and allow the engine to continue running until it runs
out of fuel.
3. Turn the key to the off position.
Caution:
In an emergency, turn the key to the off position, and close the fuel valve. Backfiring may occur
when using this method.
MOUNTING PAD AND OTHER ATTACHMENTS
(WARNING: TURN OFF UNIT BEFORE STARTING PAD INSTALL)
(WARNING: REMOVE LP TANK BEFORE TURNING OVER THE MACHINE)
To mount or remove a pad, tilt the machine back until it rests on the back wheels. Unscrew the pad-
lock nut while gripping the pad and pad driver. Position a new pad concentric with the pad driver and
retighten with the pad-lock nut.
To remove the pad driver, tilt the machine on its side. Use a 3/4" wrench to hold the main shaft which
is located between the four bolts in the front and on the top of the machine. Then, rotate the pad
driver counterclockwise to unscrew it from the main shaft.
For long life and best results always use genuine TORNADO® accessories.
MAINTENANCE OF THE PAD HOLDER
Remove the pad holder when the machine is not in use, and hang on wall peg or similar holder.
POLISHING
Use 3/4" to 1" thick BEIGE high speed burnishing pads. Floors should be dry mopped to remove grit.
SPRAY BUFFING
Use 3/4" to 1" thick HOG HAIR high speed burnishing pad. The spray buff solution should be applied
to the floor ahead of the machine. Do not run the machine into the spray or mist of the spray buff
solution.
DAMP BUFFING
Use 3/4" to 1" thick BEIGE high speed burnishing pad. Use a well-wrung out mop to apply damp
buffing solution. Go over dampened surface with machine until surface is dry and has a high glaze.
STORING
Store with pad off the floor by tilting machine back on the support wheels.
10