Commercial Electric CER6730D Instrucciones De Instalación página 2

3. Plug the FEMALE CONNECTOR of the RETROFIT TRIM
onto the MALE CONNECTOR of the SOCKET ADAPTER
ASSEMBLY. (FIG. 5)
4. If using TORSION SPRINGS, squeeze both TORSION
SPRING arms together and insert into the TORSION
SPRING SLOTS (or C-CLIPS) of the CAN. (FIG. 6)
5. Tuck all wires into the CAN and carefully push the
RETROFIT TRIM into CAN. (NOTE: To provide enough
room in shallow cans, carefully position SOCKET ADAPTER
and SOCKET adjacent to the side of the LED DRIVER prior
to inserting the RETROFIT TRIM into the CAN.) (FIG. 4 & 6)
LED HOUSINGS
1. Plug the FEMALE CONNECTOR of the RETROFIT TRIM
onto the MALE CONNECTOR of the HALO HOUSING. (FIG.
5)
2. If using TORSION SPRINGS, squeeze both TORSION
SPRING arms together and insert into the TORSION
SPRING SLOTS (or C-CLIPS) of the CAN. Tuck all wires
into the CAN and carefully push the RETROFIT TRIM into
CAN. (FIG. 6)
_____________________
DRIVER REPLACEMENT
1. DISCONNECT MAIN POWER AT FUSE OR CIRCUIT
BREAKER.
2. Pull the RETROFIT TRIM down from the RECESSED
HOUSING. Unplug the FEMALE CONNECTOR of the
RETROFIT TRIM from the MALE CONNECTOR of the
SOCKET ADAPTER ASSEMBLY. (FIG. 5)
3. Remove the REFLECTOR RING, REFLECTOR and LENS.
4. Remove the DRIVER SCREWS and separate the old LED
DRIVER from the CAST HEAT SINK. (FIG. 7)
5. Detach the LED DRIVER QUICK-CONNECTOR from the
LED TERMINAL BLOCK. (FIG. 8)
6. Mount the new LED DRIVER onto the CAST HEAT SINK
using the previously removed DRIVER SCREWS. (FIG. 7)
7. Insert the new LED DRIVER QUICK-CONNECTOR to the
TERMINAL BLOCK. (FIG. 8)
8. Replace the LENS, REFLECTOR, and REFLECTOR RING.
9. Re-install the RETROFIT TRIM into the RECESSED
HOUSING. (FIG. 6)
FIG. 5
FIG. 7
C D L
Dimmable LED Driver
CAUTION:
AC INPUT:
Risk of Electric Shock
120 Vac/Max 200 mA
60Hz
Damp Locations
L-BLACK
For Indoor Use Only
N-WHITE
• Tc
Made in China
ATTENTION:
DC OUTPUT:
RISQUE DE CHOC POUR
50-66V
EMPLACEMENTS
Red:+ Black:
SECS SEULEMENT
Regulated current:
USAGE INTÉRIEUR
150 mA
SEULEMENT
FIG. 6
FIG. 8
MODEL:
CDLPS150R10
PF >0.9
____
_ _ _