Transporting - Southland SELS60 Manual Del Operador

Maintenance
• Save all instructions
Sharpening the Wedge:
After using the Log Splitters for some time, sharpen the wedge of the Log Splitter using a fine-toothed file and
smooth any burrs or crushed area along the cutting edge.
Storage:
• Before storing make sure the Log Splitter is clean and dry.
• Store equipment in a clean, dry area. Store machine away from sparks, open flames, pilot lights, heat and
other ignition sources.
• Lightly lubricate all Log Splitter surfaces and moving parts to prevent rust. (see "Maintenance")
• Store indoors or protected area during severe weather and winter months.

Transporting

• Save all instructions
Transporting the Log Splitter:
Always place the Log Splitter on a protective mat when transporting to protect against damage to vehicle.
Remove from vehicle immediately upon arrival at your destination.
Always use two adults to load or unload the Log Splitter. Tighten the vent screw before moving or transporting
to prevent fluid leakage. When transporting the Log Splitter in a vehicle, trailer, etc., make sure the vent screw is
tightened and the unit is secured with straps to prevent tipping. Use care when driving to prevent tipping the unit
over in the vehicle. Damage can occur to the Log Splitter or surrounding items if the Log Splitter is tipped.
Questions? Call Toll Free at 1-800-737-2112
(Continued)
EN - 11
Copyright © 2018 MAT Engine Technologies, LLC