Marking for hazardous
Component
area on the motor
nameplate
Ex n + Ex t
Winding
Ex d + Ex t
Class I Div. 1
Class I Div. 2
Class II Div. 1
Bearing
Notes:
1) The number and type of the installed protection devices are stated on the accessory nameplate of the motor.
2) If the motor is supplied with calibrated resistance, (for example, Pt-100), the motor monitoring system must be set according to the
operating temperatures indicated in Table 6.6
The non-isolated part of the accessory cables should not exceed 1 mm up to the connector as shown in Figure
6.16.
Table 6.6 - Maximum activation temperature of the thermal protections.
Hazardous area where
the equipment will be
installed
Ex d
Ex d
Ex n
Ex n
Ex t
Ex t
Ex e
Ex e
Ex n
Ex t
Ex d
Ex t
Class I Div. 1
Class I Div. 2
Class II Div. 1
All
All
Figure 6.16 - Connection of the accessory cables to the connector.
www.weg.net
Max. operating temperature (°C)
Alarm
Tripping
130
150
130
155
120
140
-
110
140
155
-
140
140
150
-
140
130
150
130
155
120
140
110
120
Manual of Electric Motors
101