Drying Rack - Maytag MD-33 Guia Del Usuario

Drying Rack

Installing the Drying Rack:
1. Open dryer door.
2. Position drying rack in tumbler placing the two rear
legs in the two recessed areas in the back wall of the
dryer.
3. Place the front lip of the drying rack on top of the lint
filter.
4. Place items to be dried on the rack, leaving space
between them so air can reach all the surfaces.
5. Close the dryer door.
6. Use the Time Dry cycle. Set the Control Dial on
Drying Rack (select models) or select time according
to moisture and weight of item. Start the dryer. It
may be necessary to reset the timer if a longer drying
time is needed.
Storing the Drying Rack:
On dryer sides:
The drying rack hanger fits between the dryer top and
the dryer cabinet.
1. Place the flange on the hanger in the seam between
the top and the cabinet. Push all the way in.
2. Face the top of the drying rack toward the side of the
dryer cabinet.
3. Place the drying rack handle over the lip of the hanger.
On dryer back:
1. Place the drying rack hanger between the dryer top
and the dryer cabinet just below the back of the con-
trol panel.
2. Place the flange in the seam and push all the way in.
3. Face the top of the drying rack toward the back of the
dryer cabinet.
4. Place the drying rack handle on the lip of the hanger.
NOTE: If not included with your dryer, contact
If not included with your dryer, contact your Maytag
your Maytag dealer for the accessory kit
dealer for the ??? accessory kit or call 1-800-688-8408.
MAL1100AXX or call 1-800-688-8408.
(select models)
Handle
Front
SUGGESTED ITEMS
Washable sweaters (block to
shape and lay flat on rack)
Stuffed toys (cotton or
polyester fiber filled)
Stuffed toys (foam or
rubber filled)
Foam rubber pillows
Sneakers
WARNING: Drying foam rubber, plastic or
rubber on a heat setting may cause damage to
the item and could lead to a fire hazard.
Flange
Lip
SUGGESTED
TEMP. SETTINGS
Heat
Heat
Air Fluff
Air Fluff
Air Fluff or Heat
Rear Legs
8