V2 CITY1-EVO Manual De Usuario página 56

PARAMETER VALUE
SPiA
no
W.L.
FLSh
LP.PA
no
Si
Strt
StAn
no
APCh
PrES
oroL
StoP
no
ProS
invE
Fot1
no
APCh
Fot2
CFCh
Ch
no
DESCRIPTION
Low voltage lights
This menu allows setting the operation of the low voltage lights
output
Function deactivated
Indicator light operation: Indicates the status of the gate in real-time.
The type of blinking indicates the four possible conditions:
- GATE STOPPED: Light off
- GATE IN PAUSE: the light is on, fixed
- GATE OPENING: the light blinks slowly (2 Hz)
- GATE CLOSING: the light blinks quickly (4 Hz)
Flashing light operation (fixed frequency)
Flashing light during pause time
Function deactivated
Flashing light will be on during the pause time too
Activation inputs (START and START P.)
This menu allows selecting input operation modes (see chapter 5.4)
Standard mode
Start inputs from terminal board are disabled.
Radio inputs operate in standard mode
Open/Close command
Dead man operation
Timer mode
Stop Input
The input STOP is not available
The input STOP stops the gate: pressing the command START the gate
continues the motion
The command STOP stops the gate: at the next START the gate starts
moving in the opposite direction
Photocell 1 input
This menu allows enabling the input for type 1 photocells, that is to
say, photocells active both during the opening and closing phase
Input disabled
Input enabled
Photocell 2 input
This menu allows enabling the input for type 2 photocells, that is to
say, photocells non active during the opening phase
Input enabled even at standstill gate too
Input enabled for the closing phase only
m
WARNING: If the photocell is damaged the gate is opened
anyway.
Before closing the test of the photocell (if enabled) will detect
the fault and prevent the gate from closing.
Input disabled
StAn
- 54 -
AntE SCor
MEMO
no no
no no
StAn StAn
no no
no no
CFCh CFCh