Troubleshooting
If your appliance develops a fault, please check the following table before making a call to
your retailer.
Fault
The appliance is
not working
appliance Appliance is located near a heat Move the refrigerator to a more
The
turns on, but the source or air flow to the condenser is suitable location
temperature is too being interrupted
high/low
The appliance is Movement of water to the drain is
leaking water
The appliance is
unusually loud
Probable Cause
The unit is not switch on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Ambient temperature is too high
Unsuitable foodstuffs
stored in the appliance
Appliance is overloaded
The appliance is not properly levelled Adjust the screw feet to level the
The discharge outside is blocked
obstructed
The water container is damaged
The drip tray is over flowing
Loose nut/screw
The appliance has not been installed Check
in a level or stable position
Action
Check the unit is plugged in correctly
and switched on
Call your agent or qualified
technician
Replace the fuse
Check power supply
Call
your
technician
Defrost the appliance
Call
your
technician
Check doors are shut and seals are
not damaged
Increase
appliance to a cooler position
are
being Remove
foodstuffs or blockages to the fan
Reduce the amount of food stored in
the appliance
appliance(If applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Call
your
technician
Empty the drip tray(if applicable)
Check and tighten all nuts and
screws
change if necessary
agent
or
agent
or
ventilation
or
any
excessive
agent
or
installation position
EN
qualified
qualified
move
hot
qualified
and
19