Instruction Manual; Commissioning; Setup Recommendations; Wall Mounting - Renfert Twister Instrucciones Para El Servicio

Symbols
This manual contains symbols also found
on the appliance itself with the following
meaning:
Danger!
Immediate risk of injury.
Please observe accompanying
documentation!
High Voltage!
Danger – high voltage.
Caution
Risk of damage to the appliance
if the instruction is not followed.

1. Commissioning

1.1 Setup Recommendations

Operate the appliance at room tempera-
ture 15 - 30ºC [59 – 86ºF].
When setting up the appliance, please
note the following:
• Do not place the appliance under a heat
source.
• Do not place the appliance in front of
open windows.
• Do not set the appliance up where it will
be subjected to direct sunlight.
• Do not subject the appliance to high
humidity.

1.2 Wall Mounting

Please have the following items on hand:
• pencil,
• drill template,
• Phillips head screwdriver,
• drill
• drill bit 8 mm [5/16th inch] - appropriate
for the wall material.
EN
Other symbols are explained when dis-
played.

Instruction manual

1. Establish optimum working height
2. Align the drill template and mark the
3. Drill the required holes >>> depth at
4. Insert the dowels (Fig. 3).
5. Screw the top screws into the dowels.
6. Screw the lower mounting bracket into
7. Hang the appliance on the wall
8. Secure the device by tightening the
- 2 -
Notice
A general notice that improves and
eases use.
For indoor use only.
Disconnect from mains supply
before opening the appliance.
The appliance complies with ap-
plicable EU directives.
Within the EU, this device is
subject to the provisions of the
directive 2002/96/EG (WEEE
directive).
Make sure the wall on which you
intend to mount the device is
capable of bearing its weight.
Please ensure that there are no
electric cables or water pipes
running through the wall at the
place of installation!
(Fig. 1).
drill holes (Fig. 2).
least 55 mm [2.2 inch].
Allow the screws to protrude 9-10 mm
[0.35 - 0.4 inch] (Fig. 4).
place (Fig. 5).
(Fig. 6).
knurled nut (Fig. 7).
Tighten the knurled nut securely.