GreenWorks Pro GPW 2300 Manual Del Operador página 20

OPERATION
Black - Soap spray tip
■ The black soap spray tip, is used for soap application. Soap is applied
under low pressure high volume for optimum performance. Soap cannot
SOAP
be applied under high pressure with this machine.
Turbo Nozzle Tip
■ This nozzle rotates in a zero to 15 degree circular motion spray pattern
to break down tough dirt and grime. The spray pattern can cover area of
4 to 8 inches wide, depending on the distance between the tip and the
TURBO
surface being cleaned.
W A R N I N G
NEVER change spray tips without engaging the lock-out on the trigger handle and NEVER point
the wand at your face or at others. The quick-connect feature contains small springs that could
eject the spray tip with some force. Failure to heed this may cause personal injury.
TO DISCONNECT A SPRAY TIP FROM THE SPRAY WAND ONCE THE CLEANING
JOB IS COMPLETE:
• Turn off the pressure washer and shut off the water supply. Pull trigger to release water
pressure.
• Remove the spray tip by placing hand over spray then pulling back the quick-connect collar.
Place spray tip in the tip storage area on the units folding handle.
USING THE SPRAY WAND TRIGGER
For greater control and safety, keep both hands on the trigger handle at all times.
• Pull back and hold the trigger to operate the pressure washer.
• Release the trigger to stop the flow of water through the tip.
TO ENGAGE THE LOCK-OUT:
• Push the lock-out down until it clicks into the slot.
TO DISENGAGE THE LOCK-OUT:
• Push the lock-out up and into its original position.
Locked
See Figure 12.
20
Unlocked
Fig. 12