Assembly - Craftsman 315.CG1150 Manual De Operacións

UNPACKING
This product requires assembly.
 Carefully lift grill from the carton and place it on a level
work surface.
WARNING:
Do not use this product if any parts on
the Loose Parts List are already assembled to your
product when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result in
serious personal injury.
 Inspect the grill carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected the grill, identified all loose parts,
and satisfactorily operated the grill.
NOTE: Some loose parts are located inside the grill
assembly beneath the firebox hood.
 If any parts are damaged or missing, please call
1-800-932-3188 for assistance.
WARNING:
If any parts are damaged or missing, do
not operate this grill until the parts are replaced. Use
of this product with damaged or missing parts could
result in serious personal injury.
CAUTION:
Some parts may contain sharp edges
that may cause personal injury. Wear protective
gloves if necessary.
STEP 1: ATTACHING THE WHEELS
See Figure 5 - 6.
 With the grill out of the box and packaging removed,
place the grill right side up on flat surface.
 Locate the holes in the stand legs.
 Slide the axle (I) through the square hole in the left
stand leg and then through the round hole in the right
stand leg.
 Install the hitch pin (FF) into the hole in the axle to
secure it in place.
 Raise the grill, slide washer (DD) and wheel (E) onto the
axle.
 Using a second washer (DD) and screw (BB), secure
the wheel to the stand. Securely tighten screw.
 Repeat this process to secure the other wheel.

ASSEMBLY

SQUARE
HOLE
WASHER
STEP 2: ATTACHING THE SIDE HANDLE
See Figure 7.
 Locate the handle mounts on the firebox.
 Align holes in side handle (F) with holes in mounts.
 Install front handle using phillips screws (EE). Securely
tighten screws.
SCREW
SIDE
HANDLE
8 — English
AXLE
HOLE
ROUND
HOLE
AXLE
HITCH
PIN
Fig. 5
WASHER
SCREW
Fig. 6
MOUNT
Fig. 7