Kalor Cloe 17B Manual De Instrucciones página 63

Tabla de contenido

Idiomas disponibles

Following the principles of operation of the various hydraulic diagrams.

Important considerations:

•

healthcare will always have priority

•

There are three types of stand-by:

Type 01: the ambient temperature detected by the probe on the board has reached the SET AIR set

Type 02: the water temperature in the Hydro Insert has reached the SET H2O set

Type 03: the external thermostat has detected that the desired temperature has been reached and therefore the

contact is open.

In this specifi c case the Hydro Insert behaves as follows:

If the thermostat carries voltage to the card causing faults, the warranty will expire.

To confi gure the thermostat, simply remove the jumper on the THERM terminal (see the tab on page 16) and connect our

room thermostat, OPERATION BY A SPECIALIZED TECHNICIAN.

How to select the type of Stand-by (OPERATION BY A SPECIALIZED TECHNICIAN):

Press the SET button; press button

it by pressing the SET key again. Press the

The display will show the different stand-by modes mentioned above, choose the mode using the

NOTE: The hydraulic scheme 00 is set by default, the WINTER season with stand-by mode 02.

When the Hydro Insert is switched off manually or by programming, automatic ignitions exit from a stand-by state will

not be possible.

How to enable or disable the stand-by mode:

Press the SET button. With the

to enable (ON) or disable (OFF) the Hydro Insert stand-by function.

Press the ON / OFF button to exit

Let's see specifi cally the behavior of the Hydro Insert according to the hydraulic scheme, the presence and

the stand-by mode and the chosen season

to go to menu 09. Press the SET button again. Enter the access key and confi rm

key to go to menu 9-5.

., key, go to menu 05 and confi rm with the SET key. Use key

and

keys.

sto select whether

107

Tabla de Contenido

Tabla de contenido