Craftsman Laser Trac Manual Del Operador página 31

NON-SCRATCH BASECOVER (Fig.19)
Z_ WAR NING:
ALWAYSunplug saw from the power source BEFOREmaking
any adjustments or attaching accessories.
Your saw tnctudes a ptastlc non-scratch base cover (see Fig_19)°Attach It to your saw's
base when you are cutting workptecesthat have delicate surfaces (finishes) such as
vinyls, plastics, fiberglass, lamlnate flooring and tiles that could easfiy be scratched or
scraped with the steel base on the saw.
Fig. lg
[ Z_WARNING:
To ensure safety and retlablllty,all repairs should be
performedby a qualified service technician at Sears Service Center.
f
I _WARNING:
For your safety,ALWAYSturn off switch and unplug circular saw from the power source before performingany maintenanceor cleaning, I
It has been found that etectrtctoolsare subject to accelerated wearand possible
premature failure when they are used to work on fiber glass boats and sports cars,
wallboard, spackling compounds or plaster.The chips and gdndings from these materials
are highly abrasive to electrical tool parts, such as bearings, brushes, commutators, etco
Consequently,It is not recommended that this tool be used for extended work on any
f_berglassmaterial, wallboard, spackllng compound or piaster. During any use on these
materials, It is extremely importantthat the tool is cleaned frequently by blowing with an
air jet.
i z_WARNING:
Always wear safety goggles or safety glasseswith side
shields during powertool operations,or when blowing dust, if operation Is
dusty,also wear a dust mask,
3'1