3
Description
3.1
Overview of the product
3.2
Intended use
The product described is a hand-held cordless drill / driver. It is designed for drilling in steel, wood, plastic,
cellular concrete and masonry and for driving and removing screws.
▶ Use only Hilti Liion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series with these batteries.
3.3
Items supplied
Drill / driver, side handle, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
3.4
Li-ion battery state of charge display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Liion
battery. The Liion battery state of charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery charge state LEDs blink, please refer to the information given in the Troubleshooting
section.
14
English
1
@
;
=
%
&
(
)
+
§
/
:
∙
Meaning
Charge state: 75 % to 100 %
Charge state: 50 % to 75 %
Charge state: 25 % to 50 %
Charge state: 10 % to 25 %
Charge state: < 10 %
The battery has overheated.
The power tool has overheated or is overloaded.
Pivotable side handle
Chuck (keyless chuck / hex bit holder)
Torque and operating mode selector ring
Two-speed gear selector switch
Forward / reverse selector switch with safety
lock
Control switch (with electronic speed control)
Vibration-absorbing grip
Illumination
Belt hook (optional)
Battery
Charge state and fault display (Li-ion battery)
Release button with additional function
(charge state display activation)
2118917
*2118917*