Skil 3610 Instrucciones De Operación Y Seguridad página 37

WARNING
Adjusting the 90° Stop:
4 and then adjust the angle spinning jam nut 3
Adjusting the 45° Stop:
Adjusting the Blade Tilt Indicator:
3
(Fig. 7).
WARNING
12
WARNING
WARNING
WARNING
1. Place the set of blade guard in position 45 º
2. Remove one side of the table insert (Fig. 13). See section
"Table Insert"
3. Raise the blade 2 at the maximum height by lifting wheel in
the counterclockwise direction (Fig. 13).
4. Remove the axle nut 4 and flange 5 (Fig. 14) using keys 7
and 8 (Fig.15)
5. Remove any dust on the two blade rings before installing the
blade. Install a blade 10 "(25.4 cm) *. Install a blade on the
axis with the teeth of the blade pointing toward the front of the
saw. To avoid injury, do not use blades more or less than 10"
in diameter andaxis 5 / 8 ".
* For countries that use discs with an internal diameter of 30mm,
you should put the ring 5mm (item available along with the disk)
5
37.
3