Tabla de contenido
Publicidad
ELECTRICAL ADJUSTMENTS
ALTERNATOR DRIVE BELT - ADJUST
$% 86.10.05/20
Check
1. Disconnect battery earth lead.
1. Disconnect battery earth lead.
2. Raise rear of vehicle.
2. Raise rear of vehicle.
WARNING: Support on safety stands.
3. Remove road wheel(s).
3. Remove road wheel(s).
4. Remove 2 scrivets and Torx screw securing closing
4. Remove 2 scrivets and Torx screw securing closing
panel.
5. Remove closing panel.
5. Remove closing panel.
6. Check condition of drive belt. Renew a drive belt
6. Check condition of drive belt. Renew a drive belt
that shows signs of wear and splitting.
7. Apply a force of 10 kg to the drive belt at position
7. Apply a force of 10 kg to the drive belt at position
'X' and measure the deflection between the crankshaft pulley
and air conditioning compressor pulley. Deflection must be 9 -
10 mm.
ELECTRICAL
Adjust
1. Loosen nut securing drive belt, tensioner pulley.
1. Loosen nut securing drive belt, tensioner pulley.
2. Increase drive belt tension by turning the tension
2. Increase drive belt tension by turning the tension
adjusting bolt clockwise.
3. Tighten drive belt tensioner pulley securing nut to 25
3. Tighten drive belt tensioner pulley securing nut to 25
Nm.
4. Re-check drive belt tension.
4. Re-check drive belt tension.
5. Fit closing panel and secure with fixings.
5. Fit closing panel and secure with fixings.
6. Fit road wheel(s), fit wheel nuts and tighten in a
6. Fit road wheel(s), fit wheel nuts and tighten in a
diagonal sequence to 70 Nm.
7. Remove stand(s) and lower vehicle.
7. Remove stand(s) and lower vehicle.
8. Connect battery earth lead.
8. Connect battery earth lead.
ADJUSTMENTS
86-1
Publicidad
Tabla de contenido
